tj 140 typically (u1) detect on main control ic over temperature specification model lpl-18-12 lpl-18-36 lpl-18-24 dc voltage rated current current range rated power output line regulation load regulation setup, rise time voltage range frequency range efficiency(typ.) ac current input inrush current(max.) leakage current working temp. working humidity storage temp., humidity temp. coefficient vibration mtbf dimension others note packing over current over voltage 12v 36v 24v 1.5a 0.5a 0.75a 0 ~ 1.5a 0 ~ 0.5a 0 ~ 0.75a 18w 18w 18w 120mvp-p 200mvp-p 150mvp-p 3.0% 1.0% 2.0% 1500ms, 30ms / 115vac 47 ~ 63hz 80% 83% 84% 0.5a/115vac 0.25ma / 115vac protection type : hiccup mode, recovers automatically after fault con dition is removed -30 ~ 70 (refer to output load derating curve) 20 ~ 90% rh non-condensing -40 ~ +80 , 10 ~ 95% rh 0.03%/ (0 ~ 50 ) 10 ~ 500hz, 2g 10min./1cycle, period for 60min. each along x, y, z axes 18w single output switching power supply 90-132vac input only fully encapsulated with ip67 level (note.5) protections:short circuit/over load/over voltage/over tempe rature cooling by free air convection pass lps 100% full load burn-in test suitable for led lighting and moving sign applications high reliability/low cost 2 years warranty features : l p l - 1 8 s e r i e s ripple & noise (max.) note.2 voltage tolerance note.3 environment safety & emc protection safety standards withstand voltage isolation resistance i/p-o/p:3kvac i/p-o/p:>100m ohms / 500vdc / 25 / 70% rh harmonic current ems immunity compliance to en55022 (cispr22) class b, fcc part 15 compliance to en61000-3-2 class a,en61000-3-3 compliance to en61000-4-2,3,4,5,6,8,11; env50204, en55024, li ght industry level, criteria a 1207.4khrs min. mil-hdbk-217f(25 ) emi conduction & radiation above 105% rated output power hold up time (typ.) 20ms/115vac at full load 13.8~ 16.2v 27.6~ 32.4v 41.4 ~ 48.6v protection type : shut off o/p voltage, clamping by zener diode 140*30*22(l*w*h) cold start 40a/115vac protection type :shut down, recovers automatically after temperat ure goes down ip67 approved; design refer to ul1310 class 2,tuv en60950-1, en61347- 2-13, can/csa c22.2 no. 223-m91 (lvd) 0.175kg; 70pcs/13.3kgs/0.71cuft 1. all parameters not specially mentioned are measured at 115vac input, r ated load and 25 of ambient temperature. 2. ripple & noise are measured at 20mhz of bandwidth by using a 12" twisted pair- wire terminated with a 0.1uf & 47uf parallel capacitor. 3. tolerance : includes set up tolerance, line regulation and load regula tion. 4. the power supply is considered as a component that will be operated in combi nation with final equipment. since emc performance will be affected by th e complete installation, the final equipment manufacturers must re- qualify emc directive on the complete installation again. 5. suitable for indoor use or outdoor use without direct sunlight exposur e. ip67 file name: lpl-18-spec 2011-03-09 lps 90 ~ 132vac 127 ~ 186vdc
mechanical specification unit:mm derating curve static characteristics load (%) -30 0 10 20 30 40 50 70 20 40 60 80 100 (horizontal) block diagram detection pwm circuit emi filter power switching filter & rectifiers +v -v i/p control 18w single output switching power supply input voltage (vac) 60hz 90 100 110 120 132 load (%) ta=25 90 100 80 70 60 50 40 fosc : 60khz rectifiers 60 l p l - 1 8 s e r i e s ambient temperature ( ) 18awg 1015 18awg 1015 140 30 22 +v(red) -v(black) ac in dc out ac/n(blue) ac/l(brown) 300 20 300 20 3.6 3.6 3.5 3.5 3.5 3.5 file name: lpl-18-spec 2011-03-09
|
